Laser Engraving Darkening 
LASER ENGRAVING? WOULD YOU LIKE MORE CONTRAST?

BRUSH-ON DARKENING
LAZERDARC is a dry darkening compound.  Does not soak into wood under the lacquer at the edge of the lasered design like liquid boot polish.  There are no small bits of masking tape to pull out of the centers of small letters etc. as is the case when using black spray paint.  The black powder simply makes the job look like the laser burnt darker.
EASY TO USE DARKENING KIT
Laser the plaque, clean with furniture polish (Pledge) to remove all smoke residue, brush in powder, then brush off all the powder you can and clean again with polish.
 
 
 
Apply furniture polish		  
Clean plaque		  
Apply LAZERDARC
 
Brush powder into lasering		  
Brush off with small & big brush		  
Clean plaque
Used in-house since 1994
Kit containes LAZERDARC, instructions, brushes & touchup pens.
Note: Black powder can also be laser baked (see LASER BAKED COLORS)
For approximately one years supply with normal use:
Call with credit card or send $59.00 U.S. check or M.O. to:
Smoke-Wood, Dept D
Post Office Box 826
Elgin, OR  97827
We pay shipping in contiguous U.S.
Call for case prices.
See Order Page for shipping outside continental U.S.